Week 5 Day 13

1st Block :
Worked on saw stool, marked out the top for housing joint using the sliding bevel and square.I used the tenon saw to cut the inside waste. The reason why i used the the tenon saw instead of the crosscut is because it leaves a much cleaner cut. Crosscut saw to do some cuts in the middle so itll be easier to cut with the chisel. I chiseled with a diagonal motion so it leaves a smoother surface. To check if housing is square then used the flat bit of the chisel and if you see a gap then its not square when finished one joint i did the same to the other three.